I am fine with the loss of ble for the 15 minute interval.
When RTC 1 throws a timeout event, I will power on ble and schedule all my processes in the event handler. So finally, I want to switch off BLE, RTC0 and keep just RTC1 powered on and enter system on sleep mode by using the sev wfi and wfe calls. To do this please follow these steps: Open 'Settings'.
DOES WAKE UP TIME WORK IN SLEEP MODE PASSWORD
Please note that you may need to prevent your computer from asking for password after resuming from sleep. I proposed that we use the app_timer and have a timer event every 15 minutes, carry out my computations in the timer handler.īut later I found out the systems wakes up for all events (in this case softdevice events and BLE events). We then decided that we will switch off all peripherals for the entire 15 minute interval as I want to reduce power consumption to the maximum extent. Open 'Control PanelPower OptionsChange Plan SettingsChange advanced power settings', then open 'SleepAllow wake timers' node and set it to 'Enable'. Click Change plan settings for the current power plan, click Change advanced power settings, expand the Sleep section, expand the Allow wake timers section, and ensure. To do so, head to Control Panel > Hardware and Sound > Power Options. If your machine is on battery the most common scenario when using Sleep and/or Hibernate the battery may run out before any backup has completed. If your machine is in Hibernate because it was in Sleep for too long, your backup will likely not run. I want my application processes to run once every 15 minutes. For this to work, you’ll need to ensure wake timers are enabled in Windows. The option may wake from Sleep, but not from Hibernate. I used to sleep for 6 hours and wake up from the urgency to get up and get to work. I am going to try a displayport cable, but I dont see why this shouldnt work with HDMI. In reality, I lost time since I started waking up early. I looked around and this seemed like an issue with older NUCs that has since been resolved.
DOES WAKE UP TIME WORK IN SLEEP MODE DRIVERS
We are currently using the ble_app_uart example as base and we have added the necessary drivers to it. When the NUC is connected with an HDMI monitor (Samsung 4k monitor), the computer will intermittently not wake from sleep. When I initiate sleep manually via the start menu, the. I have created a sleep task and a wake up task in the task scheduler and disabled hibernation mode. I am working with Vishal on implementing the System ON Sleep mode. I want my computer to go into sleep mode at time x and wake up automatically at time y.
0 kommentar(er)
